3Y 12V 300 LED 2835 SMD LED pásek PRO 4.8W WW RA90 HS

3Y LED strips are strips with a PCB backing containing 3oz copper, which reduces Napětí: drops. The tapes are covered by an extended Záruka: (5 years for IP20 tapes and 3 years for IP65HS tapes). Each tape in this series is equipped with Blue Tape mounting tape.

Warm white Barva

The warm white Barva, thanks to pleasant light similar to the light of traditional light bulbs, is a solution suitable for installation in rooms intended for relaxation and everyday activity. Warm white light is not associated with the cold Barva of lighting typical of offices, which allows for relaxation and rest.

IP65HS LED strip

Often, increasing the degree of Stupeň krytí:ness is accompanied by a decrease in the brightness of the LED strip. The answer to this problem is the IP65HS tape. Instead of a thicker layer of silicone, a heat-shrinkable band was used, tightly covering the tape. This allows you to maintain IP65 Stupeň krytí:ness and high lighting parameters of the LED strip.

See Barvas in their natural shades

CRI informs about how the Barvas of the illuminated object are reproduced. The higher the value, the more natural the items look. Naturally, as if they were illuminated by daylight. The use of a strip with a CRI parameter above 90 allows you to reflect the actual Barva of objects in the room where the LED strip is used.

300 LED 2835 SMD strip

Diode 2835 - it is an energy-saving diode of small size. It is a more Výkon zdroje:ful alternative to the 3528 diode. Density is one of the parameters characterizing the LED strip. It indicates how many diodes are placed on a meter of tape. The more diodes there are on the LED strip, the more uniform the light emitted. This, in turn, allows for eliminating the phenomenon of beads, i.e. points of light. In addition to the density, the presence of beads is influenced by the height of the profile in which the strip and the lampshade are placed. Strips with a density of 60 LEDs per meter allow for a line of light. To avoid visible light points, it is recommended to use an LED profile with an appropriate lampshade.

Requires installation of a Výkon zdroje: supply.

The LED strip requires the installation of a Výkon zdroje: supply. When choosing a Výkon zdroje: supply, you should take into account the output Napětí: (it must be the same as the Napětí: of the LED strip), installation location and Výkon zdroje:. The Výkon zdroje: of the Výkon zdroje: supply depends on the Výkon zdroje: and length of the LED strip section. The Výkon zdroje: of the tape should be multiplied by its length. We recommend adding 10% to the calculated Výkon zdroje: of the Výkon zdroje: supply.